Looking for a little bit of assistance.
Had my photon for about a week and getting some behaviour i can't quite work out.
Getting instances of whole sections of otherwise good prints just failing as if they have sheared off.
Lcd and fep are clean and seem fine, plate has been levelled again and resin has been changed to a new fresh bottle of anycubic green.
No gribbly bits in the tank or stuck anywhere.
I've tried the same prints on my two other resin printers and not getting the same.behaviour.
Is there some sort of quirky setting I'm being too thick to notice for the photon?
翻譯年糕
Stefan Giudici
2019-10-27 16:14:58
Angus Phillips
2019-10-27 16:57:07
Rebel Wargames
2019-10-27 17:14:24
Danny Lloyd
2019-10-27 18:46:32
Julian Buhlert
2019-10-27 20:16:44
Tiernan Messmer
2019-10-27 23:54:48
