OK help needed started printing a yoda for someone (I tried to resist printing a yoda baby) seemed to print no problem but when I went to remove it the was a big crack in it and the inner supports were viable, this crack was there whilst still on the plate, could this be the walls too thin on hollowing, I checked the model in 3d builder and netfab before printing. I am using elegoo grey and never had this problem before.
翻譯年糕
Tony Vatter
2019-12-31 02:30:25
Jaxi Foley New
2019-12-31 02:42:13
Aaron McCommon
2019-12-31 02:46:46
Jaxi Foley New
2019-12-31 02:47:32
Aaron McCommon
2019-12-31 02:48:13
Jaxi Foley New
2019-12-31 02:48:35
Tony Vatter
2019-12-31 02:56:56
Douglas Rector
2019-12-31 03:30:04
Jackie Sparrow
2019-12-31 03:35:21
Jaxi Foley New
2019-12-31 03:56:02
Jackie Sparrow
2019-12-31 05:17:08
Aaron Coens
2019-12-31 14:16:01
