Hello again, following on from my exposure test I tried some new prints.
There are some details that are getting filled in (annoying as my fdm doesn't fill them in) around the filigree.
First one was:
0.05
10 exposure
1
120
5
I figured that reducing the exposure could fix the filigree area so I went down to 9 exposure in the second print (I also changed the angle) . But I started getting some flat artifacts. Is this because I reduced the exposure?
Any help with getting this to print would be most appreciated.
翻譯年糕
Chris Wolfe
2020-01-11 09:04:46
Chris Wolfe
2020-01-11 09:05:26
Peter Csaki
2020-01-11 09:36:10
Chris Wolfe
2020-01-11 09:45:52
Peter Csaki
2020-01-11 10:30:33
Chris Wolfe
2020-01-11 11:07:04
Anthony Fennell
2020-01-11 11:17:36
Chris Wolfe
2020-01-11 11:23:14
Anthony Fennell
2020-01-11 11:32:42
Chris Wolfe
2020-01-11 11:34:58
Chris Wolfe
2020-01-11 11:47:42
Chris Wolfe
2020-01-11 11:54:21
David McGyver
2020-01-11 14:01:49
Chris Wolfe
2020-01-11 14:03:22
Chris Wolfe
2020-01-11 14:04:51
David McGyver
2020-01-11 14:05:50
David McGyver
2020-01-11 14:12:41
Chris Wolfe
2020-01-11 14:13:51
Ryan Tudor
2020-01-11 14:28:43
Ryan Tudor
2020-01-11 14:29:52
Chris Wolfe
2020-01-11 14:30:47
Chris Wolfe
2020-01-11 14:31:01
Peter Csaki
2020-01-11 20:19:18
Peter Csaki
2020-01-11 20:21:59
Ryan Tudor
2020-01-11 21:59:34
Ryan Tudor
2020-01-11 22:00:57
Ryan Tudor
2020-01-11 22:06:55
