Anyone able to help me figure this out? I have a Anycubic Photon, or Fauxton if you know the differences. I have successful prints with using the Anycubic resin.
In fact, I had the same issue the first time I used this resin. I replaced the FEP and releveled, then printed using the Anycubic resin. Good print. I then cleaned everything and tried again with the Dragon resin. Still getting these results.
When I use the black Dragon resin I get this. I have used the setting listed on the website and have used 15 seconds and 17 seconds exposure time with similar results. Any help would be appreciated. Does my exposure time need to be much higher?
I wanted to try the resin exposure test but it doesn't appear you can do it with Fauxton.
翻譯年糕
Nick Robinson
2020-01-06 06:32:09
Mark A. Dittenber
2020-01-06 06:35:43
Nick Robinson
2020-01-06 06:40:10
Mark A. Dittenber
2020-01-06 06:42:07
