HELP!!! my first prints don't attach on Z-plate.
First try (with manual instruction):
set Z-axis moving the plate until paper sheet moves not freely.
fix the plate with wrench
set Z-height as 0 (Tools -> Z=0)
PRINT
Second try (following this video
https://www.youtube.com/watch?v=j6XHlSyj2ZU
)
set Z-axis moving the plate until paper sheet moves not freely.
fix the plate with wrench
move up the plate and put the vat in its slot
move the plate down until the vat moves not freely.
set Z-height as 0 (Tools -> Z=0)
PRINT
Both prints was paused (3-5%) in order to check if it was attached to the plate, but it was on the bottom of vat.
What i'm doing wrong??
?
救命!!! 我的第一個指紋不附在z板上.
第一次嘗試(手動指示):
設定z軸移動盤子直到紙張不自由移動.
用扳手修理盤子
將z高度設定為0 (工具-> z =0)
印刷
第二次嘗試(關注這個視訊https://www.youtube.com/watch?v=j6XHlSyj2ZU)
設定z軸移動盤子直到紙張不自由移動.
用扳手修理盤子
抬起盤子, 把增值稅放進它的位置
把盤子向下移動, 直到增值稅不自由移動.
將z高度設定為0 (工具-> z =0)
印刷
兩張列印都暫停(3-5 %), 以檢查是否附在盤子上, 但它在增值稅底部.
我做錯了甚麼??
?
·
查看原文
·
為此翻譯評分
Kyle Harris
2020-01-03 22:33:35
Paolo Ceccarelli
2020-01-03 22:44:25
Seber Dra
2020-01-03 22:46:23
Allison Janssens
2020-01-03 22:46:36
Adam Scaramella
2020-01-03 22:46:40
Allison Janssens
2020-01-03 22:50:15
Mike Michaels
2020-01-03 22:50:30
Chase Hughes
2020-01-03 23:57:46
Paolo Ceccarelli
2020-01-04 00:59:05
Richard Webb
2020-01-04 02:30:48
Chris Moore
2020-01-04 08:39:37
Nick Robinson
2020-01-04 16:04:53
Miłosz Gorzula
2020-01-05 05:40:39
Paolo Ceccarelli
2020-01-06 19:37:23
