Hi guys. This is my second print on my photon. I noticed it began peeling off the build plate so I stopped it. Is this caused by bad leveling, or too much suction? Is this why you should hollow bigger models to reduce suction? Thanks! Models are by the artisans guild. 4th picture is my successful print before this failure.
翻譯年糕
Alexander Bayerdorffer
2020-01-19 13:29:00
Tim Moulton
2020-01-19 13:53:59
Cory Curtis Merrill
2020-01-19 13:55:29
Tim Moulton
2020-01-19 13:55:34
Clint B. Kauffman
2020-01-19 13:58:27
Griffin Smits
2020-01-19 14:01:29
Kris Leon
2020-01-19 14:16:30
Ben Brooks
2020-01-19 15:51:08
Richard Humble
2020-01-19 17:24:19
Liam Plotts
2020-01-20 03:50:12
Griffin Smits
2020-01-21 11:57:44
