Hi. I have been printing with my new Photon S for about a week - new to everything so learning all at once, including cad. This is the size range that I am working in - ruler for scale - making stamps/molds to use with fine clays. I am able to print raised lines with no issue, but all of my small details that are negative/indented are lost. Cleaning is not an issue - while I can see a vague tracing of the lines that should be there, the resin in the recesses is cured. (IPA, scrubbing, ultrasonic cleaner). Included a screenshot of slicer - this was one of the longer exposure times I tried for green.
I am printing directly onto the plate - have tried different thicknesses, up to about 4mm. Indented areas are supposed to be 1-1.5mm deep. I have fiddled with the exposure times according to the suggestions here & on the spreadsheets. Switched from anycubic green to anycubic grey for a couple of days (hated the grey, had even less success, so switched back to green). I also like that I can see what is happening with the clay through the translucent resin.
Excuse the breakage - I have canned air on the way which I have seen is helpful for removal from plate. And if it matters, my test print was perfect, bed leveling has not been an issue thus far. Temp 18-21c.
Super frustrated seeing all the amazing prints here with fine detail & not being able to get a simple line! Thanks in advance for your helpful suggestions.
翻譯年糕
Douglas Michael
2020-01-20 10:40:38
Jen C. Cleere
2020-01-20 10:49:41
Douglas Michael
2020-01-20 11:06:19
Jen C. Cleere
2020-01-20 11:20:12
Douglas Michael
2020-01-21 07:25:56
Jen C. Cleere
2020-01-21 07:57:33
Douglas Michael
2020-01-21 08:17:13
Pablo Coralio Ballester Pla
2020-01-21 15:49:54
