Hi!
So I am a proud owner of a Photon (luckily, the original, not a fauxton), bought last week with firmware 4.2.17
A couple of days ago, I got hit by the random freeze/reset/restart failure. After the first layer, the photon crashes and reboots, leaving me with the cured first layer of resin and having to clean up.
I can usually resolve the issue by turning off the printer, unplugging the usb stick, unplugging power for a couple of minutes. Replug power cord, turn on, and replug usb stick. If I want to start another print back2back, I will receive the first layer-freeze-restart error.
I have so far: checked the usb cable connections (inside back panel), which looked fine.
Through research, this seems to be an issue with some ICBuffer? Will a factory reset (via factory-default.gcode) help me with my issue? Should I upgrade to FW 4.2.18 first or after the reset?
Do I have to relevel (and set new z=0) after flashing FW or resetting to factory-default?
I have also read that the EEPROM may be corrupted through unstable power supply? How can I check if my power brick is faulty?
I have also replaced the anycubic usb stick with a new branded one and will stick to that one with all my ongoing operations.
翻譯年糕
Jonathon Michael Starwalt
2020-01-26 09:31:06
Niall Forrester
2020-01-26 09:32:14
Tiernan Messmer
2020-01-26 09:33:14
Niall Forrester
2020-01-26 09:36:07
Lo Ng Sil Va
2020-01-26 09:36:29
Niall Forrester
2020-01-26 09:43:43
Bob Deblier
2020-01-26 19:11:53
