Hi, Photon S owner here since September.
Just want to tell about my solution to the smell while printing. I thought about different enclosures and vents for some time. Then I thought, why not try the complete opposite and keep it inside the printer.
So I took the whole casing apart, popped out the windows and removed the two small fans. Then covered up the holes left by the fans with some packing tape. Next was applying a string of silicone sealer at all joints and around the windows while putting it together again (this also had the bonus feature of removing some rattling noice I've had during prints).
To seal the door I put a light coat of oil on the edge of the door, and a thin bead of silicone on the other edge, then closed the door and let it sit overnight.
Having tried this for a month now, I can say it's a huge difference. Now it only gives away smell when you open the door.
Total cost: one small tube of sealer and some elbow grease.
翻譯年糕
Gary Houser
2020-01-28 03:11:08
Chris May
2020-01-28 03:30:19
Keith Porter
2020-01-28 05:39:20
Zbigniew Perski
2020-01-28 05:43:51
Magnus Larsson
2020-01-28 06:17:54
