After a successful test run, I decided to do a quick Lithophane test (40 mins) with very nice results, followed by a 20h print for a Chinese name stamp- the print came out... alright, but one of the faces on the cube seems to have slumped (it's fine, I'll have to sand down the swappable insert, but I still want to understand where the error is)- is this because of the surface tension at that angle or something else?
-I manually hollowed out the inside and added a drainage hole towards the base of the cube for the resin to flow freely out of- not sure if my choice.
翻譯年糕
Kelly Sealey
2020-02-15 21:06:15
Keif Davies
2020-02-15 21:06:49
Joshua McBride
2020-02-15 21:08:10
Steven Howland
2020-02-15 21:31:36
Joshua McBride
2020-02-15 21:45:08
