Okay so new to this printer. My test print was perfect. Now I'm trying to print small Dnd figures and had two failed attempts. Is it a must to drain the liquid and shake it up? Also recalibrate before each print.
After my first failed print I drained and recalibrated the bed. However I did not shake up the resin before I out in.
It started the print but never attached to the bed. Should I have di a closer Tolerance? I did these same exact steps before for my test print and it cane out perfect. Perhaps it's to cold in my house? Does that have an effect?
翻譯年糕
Ric Watts
2020-02-08 15:11:48
Tony Gonzalez
2020-02-08 15:12:40
Miles Redman
2020-02-08 15:15:57
Miles Redman
2020-02-08 15:16:33
Erik Herman
2020-02-08 17:11:27
Tony Gonzalez
2020-02-09 03:16:52
Tony Gonzalez
2020-02-09 03:36:45