Hey folks!. Got a problem I was hoping you could help me out with.
I started getting 'error code: T_100' after a print and was unable to print anything new.
After some sourcing on the net I was led to believe the firmware needed an update, I grabbed the files from the anycubic site support page, ran them and they seemed to update fine.
Now I'm getting this. With the added 'L_43' & 'please try to continue printing'
Any advice?
翻譯年糕
Anders Scot Hudson
2020-02-11 04:41:57
Abe Killian
2020-02-11 04:55:03
Jason Pook
2020-02-11 04:58:21
Ryan Bradshaw
2020-02-14 02:01:53
Jason Pook
2020-02-14 02:16:57
Jason Pook
2020-02-14 07:53:01
