Working on a heated enclosure for my photon at the moment. Being in Scotland it never goes above 20C (even in the summer), making it difficult to print in a garage. The heating system is based around a 260mm FDM bed, which the Photon will sit on. Planning 2 sensors for this, one at the top, above the Photon and the one already in the heated plate. Plan is for the plate to stay below 30C and the enclosure between 20C and 25C. I'll possibly add a switch to the printer, so that when a job is finished it vents the enclosure outside through a filter and switches everything off.
Has anyone done anything similar? I will be making custom PCBs for this, so might be selling them if anyone else is interested.
目前正在為我的光子做一個加熱圍欄. 在蘇格蘭, 它從來沒有超過20 c (甚至在夏天), 使得很難在車庫列印. 供暖系統圍繞著一張260毫米的fdm床, 光子將坐在這張床上. 為此計劃2個感應器, 一個在頂端, 光子上方和已經在加熱板上的那個. 計劃是讓板塊保持在30 c以下, 圍欄在20 c至25 c之間. 我可能會新增一個開關到印表機, 這樣當工作完成後, 它會通過過濾器把所有東西都關掉.
有人做過類似的事情嗎? 我將為此製作定制多氯聯苯, 所以如果其他人感興趣, 可能會賣掉它們.
·
查看原文
·
為此翻譯評分
James Reedy
2020-02-25 17:49:05
Olivier Girod
2020-02-25 17:50:48
Dan Andersson
2020-02-25 17:53:53
John Aldred
2020-02-25 17:54:12
Olivier Girod
2020-02-25 17:57:40
Olivier Girod
2020-02-25 18:04:02
Kevin Whiteside
2020-02-26 02:46:25
John Aldred
2020-02-26 02:49:50
Olivier Girod
2020-02-26 03:02:22
John Aldred
2020-02-26 03:02:45
John Aldred
2020-02-26 03:09:34
