Hello all. Being trying to print some circular bases for modelling. But as you can see the last bit has a big old rectangle on them. Other stuff prints fine but not these. I have had lots of attempts at re levelling the base, trying one at a time and re sizing them. Any ideas?
翻譯年糕
Simon Leclerc
2020-02-29 22:27:54
Simon Leclerc
2020-02-29 22:29:27
Simon Leclerc
2020-02-29 22:30:14
Frank Ramsay
2020-02-29 22:30:22
Tom Matthews
2020-02-29 22:31:23
Tom Matthews
2020-02-29 22:37:06
Robert Maefs
2020-02-29 22:52:07
Tom Matthews
2020-02-29 23:40:34
Tom Matthews
2020-02-29 23:40:46
Tom Matthews
2020-02-29 23:43:57
Tom Matthews
2020-02-29 23:54:07
Robert Maefs
2020-02-29 23:56:49
Tom Matthews
2020-02-29 23:58:59
Frank Ramsay
2020-03-01 00:20:26
Tom Matthews
2020-03-01 00:20:48
Simon Leclerc
2020-03-01 00:23:58
Tom Matthews
2020-03-01 00:25:01
Simon Leclerc
2020-03-01 00:29:14
Tom Matthews
2020-03-01 03:33:55
