Having issues printing dnd minis. Been to keeping with the settings with no success. They start printing but it's not sticking to the platform so the whole print fails. Any advise would be welcome
列印dnd minis出現問題. 一直保持設定, 但沒有成功. 他們開始列印, 但它沒有堅持在平台上, 所以整個列印都失敗了. 歡迎任何建議
·
查看原文
·
為此翻譯評分
Miles Redman
2020-03-27 13:40:12
So you end up with a thin wafer that’s a shadow of the model? Or a half printed model that falls off the plate?
Randy Roones
2020-03-27 13:45:15
Neither. The first layer wont stick the plate
Randy Roones
2020-03-27 13:46:27
I've level the plate, set z. This is my first print other then the set up print
Thrall Hood
2020-03-27 13:50:04
I use prusa for auto orientation and supports
Randy Roones
2020-03-27 13:55:56
罗西晟
2020-03-27 13:59:28
Not sticking to the platform:usually has 1 of 2 (or both) issues:
(however there is a third)
1) Z=0 not set tight enough
(from "home" go down until it is really tight! and then go up 0.3mm)
2) Base layer exposure not high enough
(try up base layer exposure with 10 seconds)
3) your build platform is greasy due to your skin touching contact surface.
(clean build plate contact surface (with alcohol) and let it dry, make sure no residue is left)
Randy Roones
2020-03-27 14:08:17
Aight. I'll try those out
Mark Wardle
2020-03-27 15:20:04
dial up the base exposure by 10 till the bases stick
Randy Roones
2020-03-27 18:13:29
Still adjusting the base exposure but is the rest ok? Using chitubox splicer
Patrick Haeflinger
2020-03-27 20:31:46
Increase the bottom layer count
