Ok hoping someone might have some insight on this. I’m new to resin printing and ive gotten my prints to come out great however after curing they seem to go down the drain the outside is rough and looks like garbage. I have an anycubic photon s and Elegoo Mars. Cleaning them with mean green in an ultra sonic. Curing in the wash and cure station from anycubic.
Thanks in advance
翻譯年糕
David Cloete
2020-03-11 04:26:52
Shaun Franke
2020-03-11 04:28:03
Chris Crute
2020-03-11 04:29:17
David Cloete
2020-03-11 04:29:19
Shaun Franke
2020-03-11 04:30:40
David Cloete
2020-03-11 04:35:24
Shaun Franke
2020-03-11 04:36:48
Shaun Franke
2020-03-11 04:37:02
Chris Crute
2020-03-11 04:39:29
Shaun Franke
2020-03-11 04:40:36
Dennis Hurlburt
2020-03-11 05:03:57
Shaun Franke
2020-03-11 05:08:16
El-Aras Buğra de Kabaca-Luchador
2020-03-11 05:37:47
Shaun Franke
2020-03-11 05:48:22
John Driggers
2020-03-11 05:53:42
Shaun Franke
2020-03-11 05:55:37
Mark Wardle
2020-03-11 06:36:59
Nicolas Tsagarides
2020-03-11 19:45:52
Catherine Lim Sook Yee
2020-03-12 22:33:22
Mark Wardle
2020-03-13 00:52:09
