Anycubic Photon Printer Owners 造訪社團 » 用戶發文

screen is ok but some led lamps died

LED array on the original Photon?

nope )

exactly! )

Pavel Vavilov yay, ten internet points for me!

How's the print going? Was it complicated/expensive?

Oleksandr Panforov havent tried yet. It wasnt so difficult. Cost was about 100$ including new power supply.

Pavel Vavilov pretty neat. Any printable parts required?

Oleksandr Panforov no, i used alluminium squre as a mount.

Pavel Vavilov would like to see the inside photos, if I may

front

compare

Oleksandr Panforov sure

Clean job. Nicely done

Thanks! )

Interesting Mod, have been thinking about doing this some time in the future...
Please let us know the results.

What's the point?

more uniform flux preventing underexposure towards the edge.

Test prints were totaly succed ) the mesh printed with 4s exposure

Pavel Vavilov I wonder if something similar could'v been achieved by just placing lenses over the existing UV-Leds.
and/or adding UV-led's to the existing assembly.

And then there's the LED-Driver, no idea what the original one draws (Voltage but more importantly Amps)
And what the replacement LED-Driver draws...
And if the output on the motherboard actually can handle the draw....

-edit:
Seem to have found an ali-express link to an array with LED-Driver... (just look for "80W High Power 405nm UV parallel light source")

"80W High Power 405nm UV parallel light source" - Yes, that what ive installed in my photon. But it was much cheaper.

Pavel Vavilov can the motherboard handle the LED Driver?

Xi-Sheng Luo , i changed the power supply to 24v, and connected plus pin of led driver directly from power supply, ground pin from the motherboard.