Am looking for some advice. Have been working on getting my anycubic photon operational after assembly but have had no such luck. Setup in accordance with the setup instructions, have updated the firm ware and anycubic software. I am using the gray plant based PLA and have tried to print a 28mm model three times. The only resin that has was hardened was a very small thin layer. Any advice?
翻譯年糕
Stuart Finesilver
2020-02-16 08:42:58
Fred Bey
2020-02-16 08:55:00
Fred Bey
2020-02-16 08:58:33
