Alright everyone. I need your help. Resin is monocure 3d rapid Grey.
My settings:
50um layer.
14sec xp.
Base xp is 60 and 5 layers.
I ran an xp finder test and determined it was 14 sec. The thing is i still get horrible details and layer shifts. The support-side has very poor details, almost smudged, and the other side is mediocre. I didnt pay 70 bucks for a resin that is as bad or worst in terms of exposure time than my elegoo resin, wich i run with 18sec xp and people told me that's high too! 8sec are advertised from monocure and "made for low power dlp printers". I hope i am doing something wrong.
I already tried my luck on reddit, got some great tips but still bad test. The old test is on top, new test with fresh "tuned" FEP (350hz) is on the bottom. Better detail but shit none the less. You are my last hope guys
Best regards.
翻譯年糕
Jacob Palmer
2020-03-04 21:09:17
Bob Deblier
2020-03-04 21:24:05
Scott Pavlich
2020-03-04 21:25:45
Mike Chess
2020-03-04 21:45:58
Clemens Tom
2020-03-05 02:11:54
Clemens Tom
2020-03-05 02:14:09
Clemens Tom
2020-03-05 02:18:32
Jacob Palmer
2020-03-05 05:31:44
Clemens Tom
2020-03-05 18:59:17
