Hellooooooo! Question knowledgeable ppl!!
I followed the calibration instructions carefully.
But my print got stuck on the FEP
film. I'll appreciate any suggestions.
Thank you!!
翻譯年糕
Ron Sa
2020-03-19 22:40:28
Hey ... I think you must do a releveling ... This works for me very well ...
1. Start a Calibration
2. Take a normal piece of paper
3. Get down till the paper stuck lightly
4. Align the top with bottom an tighten up the top piece
5. Look for the paper, if it still lightly stuck get more down till the paper stuck strong ...
6. If the paper stuck strong end calibration (save)
This works 4 me any time ... if your prints stucks really hard after printjob is done ... You got to close ...
Play around ... and still use IPA to clean all the stuff before printing !
Pedro Torres
2020-03-19 22:54:24
Ron Sa
thanks a lot for taking the time to help me! I really appreciate your advice!
Jenny Searcy
2020-03-19 23:17:56
I have found it useful to put some ptfe on after I clean it
Pedro Torres
2020-03-19 23:18:52
Jenny Searcy
2020-03-19 23:26:59
Ron Sa
2020-03-19 23:44:54
Pedro Torres
2020-03-20 00:02:03
Jenny Searcy
2020-03-20 00:10:51
Pedro Torres
i clean the fep with alcohol then wipe on some ptfe, make sure it’s dry and make a quick wipe with soft cloth to get off any excess. Fill the vat and off ya go
Pedro Torres
2020-03-20 00:21:37
Jenny Searcy
2020-03-20 00:22:45
Pedro Torres
someone on YouTube gave the advice, I tried it and its been working for me. Good luck.
