Blown away by the detail this thing can do this is my first print after doing test print. Anycubic grey .02 layer height 12 sec exposure 90sec base layer. Does anyone know if it is possible to get higher detail with this resin? Shout out to
Alexei Popovici - Bestiarum Miniatures
翻譯年糕
Sandro Pateishvili
2020-03-28 19:40:42
Sandro Pateishvili
2020-03-28 19:41:41
Try 10 sec, experiment with lower if it ain't perfect
Brent Mayhew
2020-03-28 19:41:48
Brent Mayhew
2020-03-28 19:42:07
Yea I'll give that a go cheers
Chris Thompson
2020-03-28 19:51:50
I generally go down in 0.5 seconds when trying to balance quality vs the whole think dropping off from supports not printing effectively. You could test print this head a few times over as safe test as wont take too long
Andy Johnny Young
2020-03-28 19:51:57
Brent Mayhew
download the Ameralabs test print and print at different exposures to gain an insight into best settings
Scott Pavlich
2020-03-28 20:09:12
Whoaaa....that’s way overexposed and ya probably got nowhere near the detail you should...8s is awesome for .04 layers....you’re doing .02(which really isn’t helping but that’s another story)
Daniel McCarthy
2020-03-28 20:32:42
looks awesome but 12 seconds sounds like you're over exposing it. Off the top of my head i'd say somewhere between 4 - 6 should be about right but i don't have a whole lot of experience with anycubic grey.
Neil Castle
2020-03-29 01:15:43
My friend you can get way better detail. I use 4 seconds for .02 with opaque grey.
