Any idea what would cause a support tree base to be printed at a random elevation as seen in the lower part. The top part was printed at the same time but turned out perfect. Thank for your help!
翻譯年糕
Andrew Glover
2020-03-31 09:04:14
Looks like you have a failed support and that is the bottom of it. Most likely it failed and was stuck to the fep and finally came lose and was attached to the print when it broke loose.
Pete Kastner
2020-03-31 09:08:23
It failed to stick to the base. Maybe increase base time by 10 seconds. Also make sure it's clean, and level
