Hey I was hoping to get some advice on what could be causing the pictured issue. It seems the last layers (the frame/handrails of the bridge) are being pulled away from the model each time I print. I have minimal issues with other, smaller prints. To try to resolve the issue, in the second print I built in additional supports (thin blocks) to the model itself (not in the slicer). This allowed me to cut away the warped supports and left the model looking good, but I would like to understand what I’m doing wrong to cause this. Any thoughts?
翻譯年糕
Patric Broborn
2020-03-23 19:40:38
Its unsupported. thats why. You need to anchor the end
Joel Ross-Sampson
2020-03-24 12:55:25
I can see that now, thanks for pointing out! Having said that, the first print (first photo) did not have this unsupported part, just the beams which were all connected to itself and was still pulled apart?
