Need Help!
For some reason, sometimes when I slice stl files with Photon Workshop it will go crazy and add a bunch of stuff all over the place to the sliced file (see added pictures). Has anyone else had this problem and if so how did you managed to fix it? Both pictures were from stl's sliced one after another. I'm not sure why it does it for some but not for others.
翻譯年糕
John Leonard
2020-03-25 12:17:14
This is a known issue when you hollow in chitubox.
FIX: Use anything else to hollow such as workshop or meshmixer.
Itse Kuiper
2020-03-25 14:01:39
Put your stl trough windows 3d builder. It will clean it for you. And yes hollow it with meshmixer!
Eli Allan
2020-03-25 14:16:20
How does one put it through windows 3d builder? just downloaded it
Nikola Pijanac
2020-03-25 15:59:31
Its not an issue with Chitubox. Its an issue with poorly created STL files. Put the file you have through something like Netfabb repair the stl and then slice you will see a big difference.
Nikola Pijanac
2020-03-25 16:00:37
A lot of artists out there create models without consideration of the birds nest mesh that they create as well. The slicer trys to slice everything it sees. You Can't hollow a model properly if you have vertices pointing in a million directions.
Geren W Mortensen Jr
2020-03-25 20:46:27
Looks like supports, and bases for supports.
Itse Kuiper
2020-03-26 00:58:41
Itse Kuiper
2020-03-26 00:58:55
Just search 3d builder in the search bar from windows
Rick Hanson
2020-03-26 04:08:21
Yeah, that's clearly Layer Zero in both pictures. The scrambled one is support bases, not a bad model.
