Hi, i have had a Photon-S since the 13th of march. It printed the test file perfectly. Then i tried two models i bougth some time ago but this is what happened: This should be the 2nd layer, i tried uptating the firmware and changing the format (photon,Photons) and also the usb but no difference. The first failed print i left it on for more time in order to see what would happen. Anyone has any ideas?
翻譯年糕
Shaun Reno
2020-03-21 09:42:57
How did you figure out your settings? What slicer are you using?
Riccardo Nadalini
2020-03-21 16:13:11
Shaun Reno
i use Prusa and then Chitubox and the settings are the base ones for the green resin. I haven't changed anything a part from curing resin settings
