I am confused as all hell right now. I printed the example paladin from Hero Forge, and it turned out ok, except for a problem with the shield due to user error with support placement. It turned out right-handed (sword in right hand).
Then I take the exact same model, make sure there's enough supports, angle it a bit more, lower the layer height, then slice and print, just like the previous one. And it turned out left-handed.
But wait, there's more! When I open the sliced .Photon file in Chitubox, it's fine. But then I look at it in the photon validator, and it's left-handed? Maybe the validator uses a bottom-up view when previewing the layers, but that doesn't explain how the right-handed model in Chitubox became left-handed when I printed it.
Does anyone know what's going on?
(ignore the chopped-off chitubox model. It couldn't load the whole thing because it was "too big")
翻譯年糕
Louis Siciliano
2019-11-27 17:37:02
Khristian Sutherland
2019-11-27 17:37:50
Louis Siciliano
2019-11-27 17:39:02
Thomassen Ølf
2019-11-27 17:41:03
Tiernan Messmer
2019-11-27 17:42:52
Khristian Sutherland
2019-11-27 17:47:34
Chris Carter
2019-11-27 17:48:39
Khristian Sutherland
2019-11-27 17:49:00
Tiernan Messmer
2019-11-27 17:49:40
Khristian Sutherland
2019-11-27 17:50:12
Roman Skrzek
2019-11-27 19:26:57
Chris Carter
2019-11-27 19:30:48
Paul West
2019-11-27 20:46:10
Paul West
2019-11-28 00:40:04
