I think the SLA gods approve of the new shelf, but they still do not give full blessing.. Massive info download below, I've been trying to rule out as much as possible:
- I cleaned my plate & vat thoroughly, re-leveled it before I ran this print.
- I'm using Anycubic brand Black resin, which I shook for 5 minutes solid to make sure I had a good mix.
- Followed the Google Doc's recommended program for Anycubic Black - .025 Layer Height, 7.5 Normal Exposure, 3.5 Off Time, 90s Bottom Exposure, 3 Bottom Layers.
- My print room can get pretty cool, so I let my space heater run in there for a bit to warm the room up to mid 60F
- Used Meshmixer's Analysis > Orientation feature on each mini. MM's supports, were first autogenerated, then forced a few additional in parts I thought needed more help. Included a screenshot of my settings.
Worth noting -- the last 2 prints I've run, the bottom of the vat clung to the LCD and wouldn't slide out easy. Enough so that when the vacuum broke, there was a good 'pop' as the seal broke. During printing, I heard nothing out of the ordinary. There was no residue on the LCD when I cleaned (I gently ran a razor over the LCD to check, no snags or residue). Could the FEP need replacing? It's a bit cloudy, and does have a few marks & crease lines in the plastic, particularly with this Anycubic Black, since the supports are much, much harder to knock off with the scraper.
翻譯年糕
Fred Breton
2019-01-02 15:55:45
Fred Breton
2019-01-02 15:55:55
Fred Breton
2019-01-02 15:56:04
Fred Breton
2019-01-02 15:56:12
Fred Breton
2019-01-02 15:56:17
Fred Breton
2019-01-02 15:57:52
Joel Dawson
2019-01-02 23:31:37
Bryan Mikolajewski
2019-01-03 00:18:11
Alex Varley
2019-01-03 00:37:20
Alex Varley
2019-01-03 00:38:02
