Hello people
?
.
I was thinking of answering another post but have another bunch of questions about the photon.
I'm a form2 user, very sarisfied with the machine (failure rate very low, precise manual support placement in Preform and very small supports tip, etc etc). I'm looking for a secondary resin printer to try to lower production costs for miniatures production, and currently looking at both the Moai and the Photon.
I did have a Wanhao D7 and couldn't achieve a decent print. Horrible Z wobble, very imprecise so didn't fit my requirements. Maybe I had a bad machine, I don't know.
The pro of the Photon is its low price both resin and machine. I see rather positive feedback on it but still have a few questions :
1. As I don't have much room left, I was wondering if it was possible to rince the prints from both machine in the same ISO alcohol container or could this cause issue with the cleaning with twi types of resin dissolved in the same tank ?
2. Is there a simple way to add a température regulation in the print chamber ? Tried same print with formlabs resin with and without the heating, and the resin is much more fluid when heated and yields far better results on the form2.
3. Is this printer really reliable ?
4. Does the software allows for manual support placement ? Don't want to have a forest of supports when only a dozen is required
?
.
Thank you all for your input on this.
?
翻譯年糕
Joey Smith
2019-01-12 02:38:51
Richard Shapiro
2019-01-12 03:02:15
Richard Shapiro
2019-01-12 03:05:11
Robert Silvers
2019-01-12 03:06:35
Robert Silvers
2019-01-12 03:09:45
Karl Grunthal
2019-01-14 17:33:42
