Anycubic Photon Printer Owners 造訪社團 » 用戶發文

after loong loong time i wanted to start using my Photon again - the reason i didn't use it for so loong was

1. no time

2. the smell

- so for the smell i choose to try this: https://www.thingiverse.com/thing:3681435

Printed with my FDM printer and looked good so far - but i did not like that the filter wiggles on the bayonet - so i redesignet that part - if you are interested you can find it here: https://www.thingiverse.com/thing:3729482

this video will show you what i mean :)

oh - btw. Thank you Vinicius Silva - i hve now a better readeble screen and metwork :)

翻譯年糕

OK - now i tried how good my 3D scanning setup is :) - the model is 27mm tall - Pictures are: original - scan - print - print primed - and then backside original - scan - print primed :) ( the print is just 0.05mm layer - so it could get better :) )

翻譯年糕

like Flint Read i also thought about prevention of the brocken screen Problem - after someone had the Problem i know, i asked him how he Removes the VAT - and i saw what may cause this also - and i also whant to show you a "emergency" instalation that could help if you have the Problem that your VAT stick to your screen. i made a Video about it - hope you understand my english :)

翻譯年糕

IMPORTAND!! I said it bevor - like some other here also - Replace your Power supply- i made a short test and measure the voltage of the original power supply - first i measure right after i plugged it in and it was 12 V - then i powered my LED strip (45 W) for 1 minute and the Voltage began to fluctuate (second Video) i did the same test with my „better quality „ supply- no fluctuations at all (first Video)
. Oh - btw - i did not had any Problems with my Original Power supply - but that shows the bad quality and it WILL make problems over time :)

翻譯年糕

I will update my VAT cover on thingiverse soon with the next parts. The bottom with inlay to use a microfibre cloth and fixing handles - the cover with outlet - i also add a bottom without the extra inlay part.

edit: ok - its up - you can find it here:
https://www.thingiverse.com/thing:2849290

its still in progress - there are more to come :)

翻譯年糕

i found out that my powersupply that i bought for my UV LED stripe has the same specs used for the Photon - since i bought a "better" quality one i decide to switch them - that was a good idea - cause now i see that my LED strip sometimes flickering with the Photon power supply - you should realy rplace it :)

翻譯年糕

I still did not find any reason to use lower layer then 0.5mm - Details are just amaizing :)

翻譯年糕

Last Print primed :)

翻譯年糕

Finaly my acrylic arives :)

翻譯年糕

Since my Printer takes now a off time i primed one of my last Print :)

翻譯年糕