Anycubic Photon Printer Owners 造訪社團 » 用戶發文

So thanks to you all im getting 100 percent bed adherence!...now i get prints that just stop between 50 and 90 percent complete...

翻譯年糕

Any clue what might cause this...see attached...multiple fep stuck prints, I have tried multiple re-levels and bed print settings, all seems to to just stick to fep... :(

翻譯年糕

Print failure...have run gcode, leveled, swapped resin, there are a few layers in the fep as well...

翻譯年糕

Still having print issues - I get a few base layers then the rest adheres to the FEP. I have ran Gcode, re-leveled, replaced the fep, and tried a different resin. Currently running anycubic green. Any Ideas?

翻譯年糕

Hey guys, having a new problem where the anycubic prints the first few layers then the whole build plate doesn't move and stays down in the vat for the full print...any clues?

翻譯年糕

Alright, newb question, I got my printer bed leveled. My test print, looked like it adhered to the plastic on the resin bed. Had the layout/design and about 2 mm of resin cured to the bed. No adhesion to the base plate. Is this likely a bed level error? Kinda new...sorry if this is a repost.

翻譯年糕