Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Seems anycubic heard the uproar
https://www.facebook.com/213562039049926/posts/650318602040932/

翻譯年糕

Anyone have ideal support settings for printing miniatures?
or just go with auto-support?

翻譯年糕

So last week I posted about some scratches in my screen but finally managed to find sometime to do the test print to see if and how they effected the print quality (after being asked to by Faye from anycubic ofical eBay retailer regarding whether a replacement was warranted) and so far I've seen more of an impact from the build plate surface (minor dents and the pattern from however the plate was finished) thoughts anyone?

翻譯年糕

So I got my photon at the start of the week and posted about a dent in the build plate, got some varied feedback but never had a chance to do anything with the printer due to life until tonight, prior to putting the build plate on I notice this square mark on the screen. Thinking it was just dust or something that had fallen onto the screen I grabbed a cloth and tried to wipe it off only to find it is in fact a group of small scratches. I've emailed the seller I purchased the printer off about whether I return it or they send me a new screen, but I'm hesitant to print anything incase they want the whole unit back. Any thoughts on where this will go from here?

翻譯年糕

So my photon arrived today but while I was unpacking I noticed a few small dents in the build plate, should I contact anycubic about a return or not worry?

翻譯年糕