Partial success!
New Settings : Layer 0.05 | ExpoTime 14s | OT 1s | BotExpo 60s | BotLayers 16
[BotExpo reduced from 90s, BotLayers increased from 10]
Using Monocure 3D Rapid Clear.
I got the model off Shapeways, used PreForm to reference recommended orientation, placed my supports using the Anycubic Software (paying attention to local minima, from now on I will be using FlashPrint for supports). Finally, I put it though the Photon File Validator software to clean up any islands.
Problem : The layers are very visible and the raft is very thin. Could my build plate be set at the wrong height? Or is this timing issue?
The third picture is for reference to the last print I made. It shows similar signs but to a greater degree.
Any advice would be greatly appreciated!
翻譯年糕
Philippe Maegerman
2018-09-19 04:15:12
Francisco José García Morcillo
2018-09-19 04:39:08
Chris Meijer
2018-09-19 05:05:25
Chris Meijer
2018-09-19 05:06:22
Ryan Lawecki
2018-09-19 05:07:38
Michael Kingsley
2018-09-19 05:10:30
Michael Kingsley
2018-09-19 05:11:09
Michael Kingsley
2018-09-19 05:11:29
Chris Meijer
2018-09-19 05:13:41
Michael Kingsley
2018-09-19 05:50:15
Michael Kingsley
2018-09-19 05:51:44
Chris Meijer
2018-09-19 05:54:14
陳彦廷
2018-09-19 06:58:28
Josh Norris
2018-09-19 09:56:27
Michael Kingsley
2018-09-19 10:36:17
Michael Kingsley
2018-09-20 19:07:19
陳彦廷
2018-09-20 19:17:15
陳彦廷
2018-09-20 19:17:35
陳彦廷
2018-09-20 19:17:46
陳彦廷
2018-09-20 19:18:34
陳彦廷
2018-09-20 19:19:30
Michael Kingsley
2018-09-20 19:31:10
Michael Kingsley
2018-09-20 19:35:15
陳彦廷
2018-09-20 19:50:33
陳彦廷
2018-09-20 19:51:56
Vinicius Silva
2018-09-21 03:51:09
Vinicius Silva
2018-09-21 03:55:13
Michael Kingsley
2018-09-21 05:28:30
陳彦廷
2018-09-21 08:32:31
陳彦廷
2018-09-21 08:33:37
Michael Kingsley
2018-09-22 00:12:03
Philippe Maegerman
2018-09-22 01:08:48
Nick Williams
2018-09-22 01:48:57
陳彦廷
2018-09-22 09:09:29
Michael Kingsley
2018-09-22 11:26:02
Michael Kingsley
2018-09-22 11:46:48
