My print came out great other than the base curling up in one corner (not sure what causes that but it stuck so I'm okay with it). I do have a question about these hollow models leaking resin. Both the bigger bust models I've printed have leaked resin out well after curing them. This latest one I've cured in the nail bed for so long that the base has turned yellow but I can still see a bubble moving in his shoulder. I've been exposed to that resin on my fingers several times now because of it seeping out and me not realizing. The way these are built traps resin inside the hollow area.. what do you guys do to avoid this?
翻譯年糕
Logan Montreuil
2018-11-25 09:11:41
Stefan Giudici
2018-11-25 09:25:10
Dave Corbett
2018-11-25 09:53:07
Hamish Grove
2018-11-25 10:04:20
Craig Nisbet
2018-11-25 14:57:57
Thomas Wright
2018-11-25 20:53:00
Nick Williams
2018-11-25 20:55:14
Thomas Wright
2018-11-25 20:56:05
Thomas Wright
2018-11-25 20:56:58
Nick Williams
2018-11-25 21:07:26
Thomas Wright
2018-11-25 21:10:24
Nick Williams
2018-11-25 21:20:40
Thomas Wright
2018-11-25 22:18:04
Stefan Giudici
2018-11-25 22:36:49
Stefan Giudici
2018-11-25 22:39:09
Stefan Giudici
2018-11-25 22:41:04
Stefan Giudici
2018-11-25 23:12:50
Thomas Wright
2018-11-25 23:16:31
Thomas Wright
2018-11-25 23:19:05
Stefan Giudici
2018-11-26 00:04:43
Thomas Wright
2018-11-26 00:06:00
Stefan Giudici
2018-11-26 00:08:15
Thomas Wright
2018-11-26 03:58:32
Craig Nisbet
2018-11-27 01:26:14