Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Matthew Todor
2020-02-17 04:45:23

Hey all! I recently replaced the mainboard on my photon, and I've been struggling to get successful prints since. I noticed after a few failures that the build plate lifts out of the vat at a slower rate, before speeding up and continuing down for the next layer. As if there are two different speeds. Before replacing the mainboard, this didn't happen. What setting controls this, and how would I go about fixing it back to the way it was before?

翻譯年糕

Alan Bullard
2020-02-17 04:50:14

Wes Mischke
2020-02-17 06:17:34

原文網址 Matthew Todor
2020-02-07 08:31:54

Hey all! My mainboard shorted out, causing the stepper motor to sound like it's binding up. I've had this issue before, and I know it means I need to replace the mainboard. The last time I was within warranty, and the support team is currently on holiday for the Lunar New Year, so where is the cheapest and fastest place to get a new mainboard?

翻譯年糕

Luke Mason
2020-02-07 08:41:49

原文網址 Matthew Todor
2020-01-05 23:51:20

Hey all! At some point between replacing LCD screens and moving homes, the glass beneath the LCD was cracked in multiple places. I've been working around it, but it has cause defects in most of my larger prints, and quite a few failures due to the supports in that area being deflected. Does anyone have any insight into replacing this glass, such as demensions or if there are exact replacements available?

翻譯年糕

Mike Johnson
2020-01-06 15:38:35

Matthew Todor
2020-01-08 10:56:05

Mike Johnson
2020-01-08 12:08:31

原文網址 Matthew Todor
2018-11-22 09:46:58

Hey all! I just finished replacing my LCD and glass, and got about three finished prints in when I ran into an odd issue I can't find any information on. When I go to move the plate, the column that turns seems to just vibrate instead of moving the plate along the z-axis. I'm pretty frustrated, considering I just spent the money to replace the LCD and glass. What are my steps (haha, get it?) from here?

翻譯年糕