One of the best decision I did is joining this lovely group. Great idea and wonderful community that always help.
I had my first print today and surprise it was a successful one. A lot of conversations was about the strong smell Anycubic resin and that's why I thought the first print will be (Rear Vent to 4" Adapter for Anycubic Photon), even though in the description it says to print it with FDM printer, so I'm not sure if it will be good enough to be used for this purpose yet.
I thought it was about to fail, as you can see from the picture, nearly the based support was going to fall down. is it because the base was to thin? how can I avoid this in the future?
I nearly haven't done any change to the stl file, haven't change any values and used auto support, I just change the orientation to fit and that's about it.
We had rain all day and I don't have a chance to direct the model to any UV light, hopefully, tomorrow will be sunny and I can do it. How long I should leave it in the sun?
Anyway here is my final model, I'm planning to use a primer and then start using it.
Thank you, everyone, for sharing all of these tips and information.
SRL file >>
https://www.thingiverse.com/thing:2877754
翻譯年糕
Jeremy Hartman
2018-12-26 17:14:44
Mohamed Nazir
2018-12-26 17:36:52
Jeremy Hartman
2018-12-26 18:07:44
Jannick Langfahl
2018-12-26 18:40:10
Vinicius Silva
2018-12-26 19:03:09
Mohamed Nazir
2018-12-26 19:21:29
Andy Smith
2018-12-26 20:46:36
Jeremy Hartman
2018-12-27 01:18:21
Mohamed Nazir
2018-12-27 07:41:08
Mohamed Nazir
2018-12-27 09:43:59
Jeremy Hartman
2018-12-28 00:43:52
Ilja Ilmar
2018-12-29 16:58:28
Andy Smith
2018-12-29 18:15:09
Mohamed Nazir
2018-12-29 19:46:39
Andy Smith
2018-12-29 19:50:09
Mohamed Nazir
2018-12-29 20:00:04
