Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Georg Petritsch
2019-09-05 12:35:06

Does anyone have experience with long term usage of printed parts in saltwater?
I want to print stuff for my reef tank, but i am afraid that the part will dissolve over time or somehow poisens the water.

翻譯年糕

Paul West
2019-09-05 12:36:30

Darren Wade
2019-09-05 12:37:29

Nathaniel Red Weidner
2019-09-05 12:41:34

Rose Stumpwater
2019-09-05 12:47:22

Daniel Terry
2019-09-05 13:34:19

Jon Carroll
2019-09-05 13:48:30

Georg Petritsch
2019-09-05 13:52:58

Bob Deblier
2019-09-05 15:15:27

David Nicholls
2019-09-05 17:03:12

John Bubuz
2019-09-05 17:27:37

Stephen Brian Palmore
2019-09-05 18:36:57

Wayne Carter
2019-09-05 19:53:55

Nicholas Hughes
2019-09-06 16:13:23

原文網址 Georg Petritsch
2019-01-26 23:58:07

Is there a gcode or a setting in firmware where i can set a delay between lowering the plate and turning on the uv light? So in case i print a hollow object without suction holes, the resin has some time to get squeezed out on that 0.05mm space between the object and the fep.

翻譯年糕

Sen Kun
2019-01-27 00:19:14

Sen Kun
2019-01-27 00:25:18

Georg Petritsch
2019-01-27 00:53:41

Sen Kun
2019-01-27 01:02:00

Georg Petritsch
2019-01-27 01:09:17

Georg Petritsch
2019-01-27 01:36:19

Sen Kun
2019-01-27 01:41:43

原文網址 Georg Petritsch
2019-01-08 14:22:47

After several hours of trying and at least one bottle of resin i figured out why my prints are not straight. anyone else had this before? (I want to print architectural and geometrical models, so you can see the error in the prints with naked eye).

Bad luck or a common problem of photon?

翻譯年糕