Anycubic Photon Printer Owners 造訪社團 » 用戶發文

It's not punctured, but does this mean it should be replaced, or is it fine to continue printing for a while?

翻譯年糕

Finally got a successful print! It took me a few tries to realize why things were failing. Really a matter of supports and orientation. I didn't realize how much suction there was especially on a solid piece like this, which resulted in things sticking to the fep.

翻譯年糕

Anyone that's ordered and used a replacement FEP film that wasn't from Anycubic? Have you noticed any difference in the quality of the film compared to the film from Anycubic? The price disparity on Amazon that I'm seeing is pretty vast but I'm concerned the cheaper ones will be of lesser quality.

翻譯年糕

So I got my used photon 2 days ago and haven't been too thrilled with the results so far. First print failed (stuck to fep, determined my leveling was too conservative). Fixed that and got the default photon.photon to print, though with some unevenness (no pics yet). I tried a new model (chinese guardian dogs) and my first attempt failed.

My second attempt was successful, but also nearly failed the same way as the first. On both attempts, they were printed at a 315 degree angle (so 45 relative to the plate), the smaller one (first attempt) printed poorly, then I added supports, scaled up, and rotated on the build plate 90 degrees. On both, supports attaching to the build plate under the butts (most mass perhaps) were lifted off of the build plate and I suspect that resulted in the conditions pictured.

I'm thinking either I need to print flat without supports or maybe some kind of raft as the mass is pulling the butt away from the plate, or, it's leveling (but since both were printed in different positions on the plate, I'm less inclined to think that).

Thoughts?

翻譯年糕