I tried doing the “Flint Read” leveling method and ran into a problem, the arm hits the vat and leaves about a 1mm gap between the plate and the FEP/LCD screen, would this explain so much randomness when printing? And can someone suggest a fix? Or am I just being dumb (I am new) thanks!
翻譯年糕
Aaron C Plante
2019-06-20 10:55:22
Drew Cski
2019-06-20 10:56:58
Fadi Ashush
2019-06-20 10:58:05
Jess Dempsey
2019-06-20 11:17:47
Jess Dempsey
2019-06-20 11:18:51
Tristan Leavers
2019-06-20 12:24:32
Goga Pop Georgievski
2019-06-20 13:18:35
Goga Pop Georgievski
2019-06-20 13:20:51
Spencer Bartley
2019-06-20 14:06:26
Dennis Back
2019-06-21 03:43:14
Josué Rodríguez Rodríguez
2019-06-21 07:00:43
George Bulte
2019-06-21 07:32:51
William David Cunningham
2019-06-21 07:39:48
Bryan Jack Sheets
2019-06-21 08:12:49
Michael Tetreau
2019-06-21 08:52:06
Santi Vilas
2019-06-21 11:16:44
Dave Williams
2019-06-21 18:58:11
Gary Houser
2019-06-22 02:55:40
Tom Hickey
2019-06-23 23:57:31
Dennis Back
2019-06-24 00:17:26
Hoghead Hoffer
2019-06-24 07:34:39