Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Michael Fairley
2019-12-11 21:23:13

Good Morning All! I can’t find the answer in the search from the group. I just got the validated 2.0, but I can’t not get files from chitubox to open in it. Saved in .stl, .chitubox, and .obj with no luck. I read online it mentioned using a .photon file, but chitubox doesn’t have that as an option.

Thanks for any help!

翻譯年糕

Richard Humble
2019-12-11 21:34:21

原文網址 Michael Fairley
2019-10-27 21:28:27

I have recently been using the new Siraya Tech fast curing gray resin with a touch of Tenatious. Since the switch My cure times went from about 10min to 10 hours (curing station or in the sun). Has anyone else had this issue?

翻譯年糕

原文網址 Michael Fairley
2019-07-23 21:43:58

After getting my new printer which failed 7 times on the test print (3 resets of the printer) I found that eSun Bio - Gray sent out a bad batch that is causing the problem. If you got the bad batch, they will replace it for free with any of their other options. The issue with the gray is being investigated, so that’s not an option.

翻譯年糕

原文網址 Michael Fairley
2019-07-16 06:36:24

I found a conversation comparing the photon, photon s, and EPAX x1. Everyone said Epax is better, but not why. Also, why do some say photon is better than the photon s?

Asking because I am trying to decide which to buy.

Thanks all

翻譯年糕

Jordan Groskopf
2019-07-16 06:41:56