Alright mates. I’ve had my printer for a week and printed nonstop flawlessly. Now my prints fall off the build plate between 25/50% complete. Leveled the bed many times, cleaned the bed spotless many time, and run 50 exposure time on bottom layer with 10 on all others. Any other suggestions? I’m using medium supports. Anycubic green resin.
翻譯年糕
Robert Cvengros
2019-08-04 05:18:08
Robert Cvengros
2019-08-04 05:19:38
Scott Pritchard
2019-08-04 05:26:04
Hugh Jeriolas
2019-08-04 05:29:04
Stefan Giudici
2019-08-04 05:32:31
Drew Delano
2019-08-04 05:33:06
Bryce Eden
2019-08-04 05:34:43
Hugh Jeriolas
2019-08-04 05:39:58
Hugh Jeriolas
2019-08-04 05:40:26
Thomas Wright
2019-08-04 06:00:13
Guajolote Messias
2019-08-04 06:22:03
Regan Fairbanks
2019-08-04 10:02:19
Will Koehler
2019-08-04 10:14:34
Hugh Jeriolas
2019-08-04 10:26:38
Hugh Jeriolas
2019-08-04 10:27:20
Rossi Searle
2019-08-05 00:53:27
Hugh Jeriolas
2019-08-05 01:29:16
Rossi Searle
2019-08-05 01:37:13
Rossi Searle
2019-08-05 01:37:31
Hugh Jeriolas
2019-08-05 02:14:48
Rossi Searle
2019-08-05 02:19:18
Hugh Jeriolas
2019-08-05 03:00:54
Rossi Searle
2019-08-05 03:01:54
Hugh Jeriolas
2019-08-05 03:02:47