Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Ben Warrender
2019-08-24 00:17:30

Hi guys me again ? is it normal for the print to be sticking to the FEP slightly before pulling free as it lifts? I recorded it but I'm not sure if you'll be able to hear it popping free over the fan noise. Cheers again ?

翻譯年糕

Scott Pavlich
2019-08-24 00:18:46

Ben Warrender
2019-08-24 00:19:43

Arnie Locsin
2019-08-24 00:21:17

Ben Warrender
2019-08-24 00:27:19

Arnie Locsin
2019-08-24 00:28:33

Ian Gill
2019-08-24 00:31:08

Ben Warrender
2019-08-24 00:43:51

Ben Warrender
2019-08-24 00:44:57

Ben Warrender
2019-08-24 00:47:05

Ian Gill
2019-08-24 02:01:27

Ben Warrender
2019-08-24 04:04:36

Vinicius Silva
2019-08-24 06:29:09

Joe Broggio
2019-08-24 23:13:33

Ben Warrender
2019-08-25 00:26:13

Vinicius Silva
2019-08-25 03:05:51

Keif Davies
2019-08-26 03:38:03

原文網址 Ben Warrender
2019-08-22 08:53:15

BEAUTIFUL!!! Haha what's happened here then? Just got my Photon today set it up and started printing the pre-loaded cube off the USB stick but about 15% into the build I noticed it was starting to stick to the FEP film slightly as it was lifting and then flicking free, any ideas anyone? From what I can tell the leveling looks ok, could it be that the Z axis is set too low? Any help would would be very much appreciated ? thanks for your time. ?

翻譯年糕