Hi everyone! So I've had the Anycubic Photon for about two weeks and I am very new to the 3D printing world. I have a few questions.
1.) How do you all remove the print from the plate without messing up the leveling of the plate? I unscrew the plate from the printer and scrape off my print, but when putting the plate back into the printer it is no longer level. I have tightened up the screw to prevent it from moving so easily and I have also been very careful when removing prints. How do some of you go weeks without re-leveling? I have to two-level between each print or the next one will fail?
2.) Sorry this may be a stupid question but I can't seem to find an answer on any forum. When cleaning off the build plate and FEP resin tank, can you just dunk both of them into IPA to clean them? Would that damage anything? Of course you would have to make sure both are dry before printing, but that seems like a quick and easy way to clean them.
翻譯年糕
Thibaut Pral
2019-09-12 00:17:46
Paul West
2019-09-12 00:20:08
Samuel
2019-09-12 00:25:52
Mike McCreery
2019-09-12 02:06:49
Herman Simpson
2019-09-12 03:01:34
Paul West
2019-09-12 03:03:13
Keira Leger
2019-09-12 03:38:15
Aaron Strome
2019-09-12 04:07:09
Samuel
2019-09-12 04:15:31
Keira Leger
2019-09-12 04:49:33
Tiernan Messmer
2019-09-12 06:55:33
