Need some suggestions. I printed this crystal off Thingiverse. The small one I printed was good, but when I printed one double the size I consistently get they wacky layers. I tried re-slicing it on a new usb but no dice. It always messes up in the same spot. Any suggestions welcomed!
翻譯年糕
Richard Flanagan
2019-09-14 05:04:43
Rose Stumpwater
2019-09-14 05:07:12
Handrez Pintubola
2019-09-14 05:07:32
Handrez Pintubola
2019-09-14 05:08:17
Nicholas Hughes
2019-09-14 05:10:28
Jeff Johnson
2019-09-14 05:11:51
Paul West
2019-09-14 05:16:32
Richard Flanagan
2019-09-14 05:16:57
Joshua Collins
2019-09-14 05:31:33
Clifford Schwankner
2019-09-14 05:57:34
Chasen Harris
2019-09-14 05:59:09
Nick Williams
2019-09-14 07:34:38
Danny Picard-Lemieux
2019-09-14 07:52:15
Richard Shapiro
2019-09-14 08:22:30
Ryan Zappen
2019-09-15 23:00:58
