Anycubic vs moon ray, up photons low moon ray, Is there any way to make it clearer?
翻譯年糕
Joey Molnar
2020-03-28 12:39:15
Have you cleaned the grease off your z-axis and relubricated it with good quality lithium grease? This should help your banding issues
Nguyễn Đình Thi
2020-03-28 12:40:28
Beau Lawrence
2020-03-28 12:41:41
Make sure you do a exposure test with the rest you're using to find the correct exposure times to get the most detail out of your prints
Nguyễn Đình Thi
2020-03-28 12:43:06
Nguyễn Đình Thi
2020-03-28 12:44:01
give me the "Skin" resin polymerization parameters
Beau Lawrence
2020-03-28 12:44:33
Nguyễn Đình Thi
2020-03-28 12:44:47
Eduardo Parati
2020-03-28 12:50:07
Looks clearly underexposed to me
Mark Wardle
2020-03-28 12:50:47
looks like the resin is overexposed. dial back on the exposure by 2
Joey Molnar
2020-03-28 12:51:32
Nguyễn Đình Thi
2020-03-28 12:52:43
Sean Howard
2020-03-28 13:28:33
is the exposure test the one where you update the firmware?
Beau Lawrence
2020-03-28 13:30:18
Robert Hamberger
2020-03-28 14:40:29
Ack. Someone has a bad case of gingivitis...
Sean O'Hayer
2020-03-28 14:58:54
Sean O'Hayer
2020-03-28 14:59:42
The Photon one looks over exposed.
Jan Pfriender
2020-03-28 15:31:09
Lucas Parard
2020-03-28 15:51:28
Lucas Parard
2020-03-28 16:13:35
Can you post the setting for the photon's print ?
Sandro Pateishvili
2020-03-28 17:55:38
Overexposed definitely on the photon
