Anycubic Translucent Red
It comes out red and clear which I like and I used hot water to get supports off, used the washing and curing station to wash and cure and a small razor to shave down the bumps I’m just curious if anyone has any tips for models like these where you can either;
A. set up supports so they don’t leave marks
Or
B. Method to remove the divits without messing up the finish
Or
C. Any other methods by which to have an easier post part.
I used prusa slicer for optimizes orient and auto supports and manually added my own where need and sliced with the photon slicer.
Any tips or tricks will, I know a lot from research and the forums but obviously not everything.
I feel like I did an okay job removing the divots but you can see the scrape marks.
I’m aware there’s just no getting around the support removal sometimes but the forum knows best!
翻譯年糕
Fred Bey
2020-03-11 11:35:21
Chris Roberts
2020-03-11 11:45:50
Colton Wilkins
2020-03-11 12:12:29
Colton Wilkins
2020-03-11 12:12:40
Christopher Barnes
2020-03-11 12:15:16
Colton Wilkins
2020-03-11 12:22:13
Colton Wilkins
2020-03-11 12:22:44
