Hi
On an other page I received the following post, not sure what to make of it or find any additional information, can anyone shed some more light on this?
"when your doing both calibration and normal prints, the key is the base or raft has a measurement and the burn layers should match otherwise over lapping layers can cause issues and over measurement.
ie if your printer isn’t tuned and your layer cure settings are puffy or incorrect, this adds extra dimension to the print layers.
Meaning 0.05 micrometer would be 2000 layers for the whole model but puffy overcured layers may be 2000 0.056 or 0.06 - so the print gradually accumulates extra dimension and scale casing issues such as failure."
翻譯年糕
Richard Humble
2020-02-19 07:16:13