Hello! So thought I’d troubleshoot here! I make handmade dice for a living and purchased my Anycubic Photon to print minis and my masters for molding my dice. The issue is while my minis print flawlessly- my masters always have resin pooling issues on the sides nearest the supports no matter how I move the supports or flip the shapes around. Any help would be appreciated!
Photos are two examples inked in to show the issue vs how it should look.
翻譯年糕
Paul West
2019-12-07 01:46:16
Jaimie Rennie
2019-12-07 01:50:17
Paul West
2019-12-07 01:54:22
Jaimie Rennie
2019-12-07 01:55:41
Sydnee Davidson
2019-12-07 02:07:33
Jaimie Rennie
2019-12-07 02:09:29
Sydnee Davidson
2019-12-07 02:10:35
Jaimie Rennie
2019-12-07 02:11:54
Rose Stumpwater
2019-12-07 02:14:37
Randy Shepherd
2019-12-07 02:17:47
Jaimie Rennie
2019-12-07 02:22:09
Derek Reihe
2019-12-07 02:22:40
Jaimie Rennie
2019-12-07 02:23:06
Derek Reihe
2019-12-07 02:26:17
Scott Pavlich
2019-12-07 02:33:11
Jason Smith
2019-12-07 02:40:05
Matthew 'Senjak' Goldman
2019-12-07 04:07:49
Jaimie Rennie
2019-12-07 06:04:46
Jamie Eastep
2019-12-07 11:13:09
Paul West
2019-12-07 11:22:27
Tobi Altebaeumer
2019-12-07 14:29:44
Jaimie Rennie
2019-12-07 14:51:00
Spencer Griffin
2019-12-09 16:42:04
Jaimie Rennie
2019-12-09 18:03:41
Spencer Griffin
2019-12-09 18:47:57
Mason Chapman
2019-12-23 08:11:00
Jaimie Rennie
2019-12-23 08:25:02
Mason Chapman
2019-12-23 08:26:32
