Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Joe Kirkus
2020-01-29 15:34:09

Quick question: If I don't hear the popping off of the FEP, does that mean that the print has started to fail?

翻譯年糕

Philip Coulson
2020-01-29 15:35:48

Lee Fletcher
2020-01-29 15:37:23

Joe Kirkus
2020-01-29 15:45:45

Adam Shield
2020-01-29 15:49:46

Matt Houghton
2020-01-29 16:01:56

Daniel Kottmair
2020-01-29 17:28:16

Michael Bradley-Robbins
2020-01-29 23:55:18

Joe Kirkus
2020-01-30 00:11:14

原文網址 Joe Kirkus
2020-01-27 08:26:13

Question for the group: if I attempt a print and it only gets through the base layers of the supports then fails, does that mean I need to up the time on the initial layers? I’m new and probably not using the right words.

Edit: nothing stuck to the build plate, I just ended up with the flat blobs of the start of the Supports on the FEP. I’ve had other stuff print fine though.

翻譯年糕

Fred Bey
2020-01-27 08:28:50

Joe Kirkus
2020-01-27 08:29:21

Fred Bey
2020-01-27 08:30:24

Scott Pavlich
2020-01-27 08:30:55

Joe Kirkus
2020-01-27 08:32:40

Stefan Giudici
2020-01-27 08:49:16

Joe Kirkus
2020-01-27 08:51:14

Mike Fatchett
2020-01-27 09:04:39

Joe Kirkus
2020-01-27 09:43:22

原文網址 Joe Kirkus
2020-01-22 10:29:09

Anyone use the anycubic eco resin? I just made the test cube, and I was curious if I should still use IPA to clean it. I read somewhere that I can use dish soap (that somewhere was the Anycubic website)?

翻譯年糕

Matthew Overbeck
2020-01-22 10:32:54