Stupid question of the day folks. Please someone tell me why there is a ball joint on the print plate? Why is it there?
It looks like the #1 complaint from users is about the crazy effort that can go into leveling these devices.
When I tighten this joint during leveling I can see the right of the plate lift a micron or two.
The second most discussed mod is one to remove this ball joint.
Even the S has a balljoint!!!
Please help out a simple Photon classic user. I cannot find this answer anywhere.
翻譯年糕
Derek Reihe
2020-02-20 07:15:33
Brett Thompson
2020-02-20 07:16:08
Derek Reihe
2020-02-20 07:16:47
Brett Thompson
2020-02-20 07:17:27
Derek Reihe
2020-02-20 07:18:23
Paul Krzywdik
2020-02-20 07:19:36
Derek Reihe
2020-02-20 07:20:08
Joel Glass
2020-02-20 07:20:25
Brett Thompson
2020-02-20 07:21:09
Joel Glass
2020-02-20 07:22:42
Mike Tate
2020-02-20 07:23:10
Brett Thompson
2020-02-20 07:23:14
Brett Thompson
2020-02-20 07:23:47
Mike Tate
2020-02-20 07:23:47
Derek Reihe
2020-02-20 07:23:49
Mike Tate
2020-02-20 07:25:13
Brett Thompson
2020-02-20 07:26:23
Derek Reihe
2020-02-20 07:26:56
Richard Humble
2020-02-20 07:28:02
Brett Thompson
2020-02-20 07:34:01
Richard Humble
2020-02-20 07:42:53
Scott Pavlich
2020-02-20 08:03:43
Leonardo Migo Araneta
2020-02-20 08:39:19
Luke Pettit
2020-02-20 09:15:09
Fred Bey
2020-02-20 09:38:12
Paul Carter
2020-02-20 10:11:08
Shawn McDonald
2020-02-20 10:13:55
Brett Thompson
2020-02-20 11:00:40
Zeb Christmas
2020-02-20 13:19:01
Bob Deblier
2020-02-20 14:20:25
Ether Quanta Deals
2020-02-20 15:03:21
Julian Kupper
2020-02-20 16:39:04
Ray Sears
2020-02-20 19:06:28
John Henry
2020-02-20 22:42:32
Andrew Rosenthal
2020-02-20 23:21:59
Shawn McDonald
2020-02-20 23:36:34
Shaun Spalding
2020-02-20 23:40:54
Derek Reihe
2020-02-20 23:41:08
Andrew Rosenthal
2020-02-20 23:48:15
Keith Yinger
2020-02-20 23:56:03
Nipuna Gunarathne
2020-02-21 00:34:50
Sean Smith
2020-02-21 01:27:27
Brett Thompson
2020-02-21 04:28:47
AusRob Kirgan
2020-02-21 06:16:12
AusRob Kirgan
2020-02-21 06:17:07
