So this is print unsuccessful print 7 out of 10. Not sure what I’m doing wrong to get these objects to print. I’ve tried releveling the bed every print. I even move the printer inside because it’s been 50 degrees outside during our cold snap. Any tips I can look into besides switching resins because it’s my next move. This is the anycubic grey resin I thought would be the most compatible because it was the same company. The printer was on a stable surface and I have tried leveling using both the paper method and the flint reed method. I turned up my printer settings to 75 sec for the bottom layers over the 60 recommended. And 11 sec per layer. I have on and off at 1 sec. this came as a recommendation from a YouTube channel 3DprintPros. It’s a new printer with less than a week in service. All I’ve calibrations look good as well. Any help is appreciated! I can’t give up.
翻譯年糕
Handrez Pintubola
2020-01-28 01:45:40
Thomas Harrell
2020-01-28 01:45:42
Tauri Icenogle
2020-01-28 01:49:50
Nipuna Gunarathne
2020-01-28 01:51:00
Ryan Kane
2020-01-28 01:51:57
Thomas Harrell
2020-01-28 02:02:25
Anthony Gutierrez
2020-01-28 02:07:31
Jim Monaco
2020-01-28 02:29:13
Ryan Kane
2020-01-28 02:35:49
Mike Fatchett
2020-01-28 02:46:03
Ryan Kane
2020-01-28 02:52:28
Ryan Kane
2020-01-28 02:55:04
Chris Pylant
2020-01-28 02:56:34
Roger Munguia
2020-01-28 03:01:12
Ryan Kane
2020-01-28 03:02:43
Chris Pylant
2020-01-28 03:03:28
Ryan Kane
2020-01-28 03:04:34
Roger Munguia
2020-01-28 03:06:00
Roger Munguia
2020-01-28 03:06:43
Derek Reihe
2020-01-28 04:49:08
Jim Monaco
2020-01-28 05:06:01
Joey Molnar
2020-01-28 11:34:58
Luke Mason
2020-01-28 15:14:10
Edward Hill
2020-01-28 21:14:04
Scott Pavlich
2020-01-28 21:27:48
Alison Friedlander
2020-01-29 01:25:52
Kris Leon
2020-01-29 09:59:45
